1. Idling: about half an hour of idling are necessary especially when a whole new matrix is in use, and it's also needed to make an idling with h2o when it really is within the high-temperature weather of summer season. This measure is taken to more decrease the affect on matrix throughout the method of welding device little bit, and also to improve the storage of maintain inner high quality when the blade is in high-speed rotation.

2. The quantity of quarry stones must be stored at over the amount of 0.5 cubic meters Diamond Saw Blades, and folks really should also make them secure within the square lumber and firmly fill in them. Moreover, each of the quarry stones really should be placed in the symmetric position of functioning platform, so that the steadiness of both operate table and uncooked stones is ensured. Needless to say there are no this kind of circumstances as rocking and shaking.

3. The adjustment in the placement switches in accordance the length, width, and height should be made to create certain which the up-and-down actions of diamond blade along with the route of charging skip are managed inside a good and reliable array. Just before the sawing, the blade cut ought to be elevated ten to 20mm higher than the top of quarry stones. If the tile cutting blade is finished, the gap among blade reduce and also the bottom of quarry stones really should be stored within the range of 20 to 40mm, and other people really should also maintain all saw blades free in the saw bite with regard to about 150 to 200mm when they are relocating across the knife relaxation, to ensure the strike diamond saw blades blades and quarry stones is averted.

4. If the idling of diamond blade is in secure position, trial cutting will probably be taken following, and it really is forbidden to start out saw blade when blade cutting edge is in speak to with quarry stones. The halt of rotating blade is also not permitted when cutting is in approach, and also the right regarding quit is once the blade is moved from saw bite https://www.yftools.com.

5. In the event you realize that quarry stones are in unstable situation, the cutting ought to be quickly stopped however. Right after repairing the quarry stones cutting might carries on and any movement of them is forbidden throughout the method of cutting.

6. When issues including deceleration are located on diamond blades when cutting, they might attribute to the belt creep, the looseness of gland nut or extreme depth of the penetration of cutting device, and abnormal pace of cutting feed.

Therefore, immediate measure must be taken to regulate the diamond saw blades.